Beginning at essentially the same time, my two Duets and 2 Booms all refuse to connect to server. Focusing here on the two Duets.
Pushed and held the button for factory reset. Rapid blinking red light followed by slow blinking red. The receiver shows on the list of players (along with the three squeezebox radios that are still working). At this point the router shows the receiver to be connected. Select the receiver with the controller, and it asks if I want to connect via ethernet or wireless. I proceed to connect via ethernet. After several minutes the controller reports a problem connecting. If I select "try again" the receiver is no longer on the list of available devices. When I start over, but attempt to connect via wireless, I get exactly the same result. Incidentally, the controller will interact with all three of my SB radios.
While the receiver is still visible in the controller's list of devices, before I tell it to connect, I can ping the both receiver and the server, so it would seem that both are connected to the LAN.
Running LMS 7.8 on both the server PC. The controllers are at version 7.8 of their software. I'm not sure what version the receivers are.
This happened with both of my SB duet receivers at the same time. I have disabled the firewall with no change.
I am seeing a similar issue with to SB Booms. All of this seemed to happen about the same time. The SB radios are working fine.
I would appreciate any help.
Pushed and held the button for factory reset. Rapid blinking red light followed by slow blinking red. The receiver shows on the list of players (along with the three squeezebox radios that are still working). At this point the router shows the receiver to be connected. Select the receiver with the controller, and it asks if I want to connect via ethernet or wireless. I proceed to connect via ethernet. After several minutes the controller reports a problem connecting. If I select "try again" the receiver is no longer on the list of available devices. When I start over, but attempt to connect via wireless, I get exactly the same result. Incidentally, the controller will interact with all three of my SB radios.
While the receiver is still visible in the controller's list of devices, before I tell it to connect, I can ping the both receiver and the server, so it would seem that both are connected to the LAN.
Running LMS 7.8 on both the server PC. The controllers are at version 7.8 of their software. I'm not sure what version the receivers are.
This happened with both of my SB duet receivers at the same time. I have disabled the firewall with no change.
I am seeing a similar issue with to SB Booms. All of this seemed to happen about the same time. The SB radios are working fine.
I would appreciate any help.